2015年6月12日 · To reset the switch to the factory defaults: Step 1 If you are using Cisco IOS XE Release 3.6.0E or later releases, enter the erase startup-config privileged EXEC command to clear the contents of your startup configuration.If you are using an …

2021年8月11日 · Is there a way to wipe out a switch to factory defaults without knowing anything about the switch? 08-11-2021 05:46 PM. Power down the switch. Hold the Mode button. Keep holding the button and apply power. See if the console goes to ROMMON or not. Reload the switch (use the power cable).

2016年4月29日 · If I skipped step 1, and tried holding the mode button, it should reset the switch back to factory default? When I hold the mode button, the lights turn amber, and the switch goes to a rommon type mode( switch:).

2024年9月25日 · If you have configured a switch and the configuration has become very complex, or if you want to move a switch from one network to other, you can reset the switch to factory defaults and configure it as a new switch. This document provides information and sample command logs to reset your switches.

Recovering the compromised device— If the key material or credentials stored on a device is compromised, reset the device to factory configuration, and then reconfigure the device. Enables privileged EXEC mode. Enter your password, if prompted. Resets the device to its configuration at the time of its shipping. factory reset command.

Recovering the compromised device— If the key material or credentials stored on a device is compromised, reset the device to factory configuration, and then reconfigure the device. Enables privileged EXEC mode. Enter your password if prompted. Use the command with all options enabled. command.

Do you know how to reset a Cisco switch to factory defaults w/wo CLI? In this tutorial, you will learn the Cisco IOS commands used to clear all switch configurations with or without CLI/console port and whether you know the enable password.

Follow the prompts to initialize the switch and reset it to factory defaults. Initiating the factory reset process on a Cisco Catalyst 3850 switch is a critical step in troubleshooting network issues or preparing the switch for a new deployment.

2021年4月12日 · Below are the commands I used. At the switch prompt, enter privileged EXEC mode. Switch# write erase. 7. Erase the Vlans. Switch# delete flash:vlan.dat. 8. Reload the switch. Switch# reload.

2022年4月6日 · In enable mode, use the command "factory-reset all". Enter the "y" key twice when prompted. The switch will boot into ROMMON. Use the command "emergency-install flash:cat3k_caa-universalk9.16.12.05b.SPA.bin". 04-06-2022 06:18 AM.