2005年12月27日 · I replaced the Hall effect sensor in the distributor; no help. I determined that the SBEC wasn't grounding the auto shutdown relay but I didn't know why. After getting a complete wiring diagram for the vehicle, I painstakingly started at the battery ground terminal and checked every connection, splice and component, found a big ground terminal ...

2008年8月25日 · (a) the only significant or practical aerodynamic improvements to the front end of the vehicle would be to 'close up the entire front end'. and, any attempted aerodynamic improvements to the front end of a vehicle will: (b) only gain 2 MPG. (c) result in an overheating engine. therefore, the tradeoff .."doesn't seem logical." Your logic is ...

2002年10月11日 · Rear wheel drive vehicles, equipped with AT or MT, should NOT be dinghy towed. These transmissions have no provisions for internal lubrication while being towed. In order to properly tow these vehicles, place the vehicle on a platform trailer with all four tires off the ground. Avoid towing the vehicle with all four tires on the ground.

2009年1月7日 · Jeep TJ Alignment Bible Wrangler Car Forums . My everyday driver is a 2005 TJ Wrangler X, and I didn’t feel I needed a monster truck so I decided to go with 30-31" tires instead of the 27" that came on my TJ.

2010年2月14日 · With vehicle running turn on all electriacal loads; put voltmeter put red lead on alternator output terminal and black lead on positive battery post. test ground circuit by putting red lead on alt case and black lead on battery neg post. should read not more than .1 volts per connection or more than 0.3v total.

2009年2月17日 · 1- Disconnect and isolate the battery negative remote cable from remote ground post. 2-Raise the vehicle. 3-Remove 3bolts attaching starter to engine. 4-Remove battery positive feed wire from starter. 5-Remove starter solenoid assembly from tranmission housing.

2003年9月21日 · also tried the onoffonoff with the unlock depressed. had doors closed and key on for the 8 to 4 jump method. locks won't cycle to indicate program mode is in effect. any help would be appreciated. thanks! ***** for anyone interested: for 1997 Chevrolet Silverado 1/2 ton pickup, use the Diagnostic terminal jumper method. jump pin 8 to pin 4 or a ...

2006年5月13日 · For 4wd remove the front skid plate to access. The secondary air injection pump is used to lower tail pipe emissions on start-up. The PCM supplies a ground to the pump relay, which energizes the pump and the electric solenoid valve. Engine vacuum is applied to the shut-off valve when the solenoid is energized.

2007年5月31日 · 4 = Chassis Ground 5 = Signal Ground 6 = CAN High (SAE J2284) 7 = ISO 9141-2 K-line 10 = SAE J1850 Bus 14 = CAN Low (SAE J2284) 15 = ISO 9141-2 L-line 16 = Battery+ NOTE: Depending on which type of vehicle you own (and which protocol is uses to transmit information), you will have a different combination of pins 2, 6, 7, 10, 14, and 15.

2006年11月27日 · Set the volt meter to D.C. volts. The most common way of testing this switch is while the engine is off, but the ignition is on, place the ground lead of the volt meter to a good vehicle ground. Looking in your service manual to locate the drive wire coming from the vehicle, going to the inhibition switch.